HVAC Tune-Ups
Regular Heater and Air Conditioning tune-ups can save you a lot of money!
San Diego (760) 631-2048
Regular Heater and Air Conditioning tune-ups can save you a lot of money!
Lower Monthly Bills
After having maintenance performed on your A/C your equipment will run more efficiently – making your electric bill go down!
Fewer Costly Repairs
Properly maintaining your A/C throughout the year can help prevent unforeseen damages and save you money on costly repairs.
6 Month Guarantee!
If your Furnace or Air Conditioner breaks down within six months after your Precision Tune-up and Safety Check, we will credit your entire investment towards the repair or replacement of your unit.
26 Point Energy Boosting A/C Tune-Up
- Blower Motor – measure amperage and voltage for proper operation
- Thermostat – test for proper operation, calibrate, and level
- Cleaning existing air filter (as needed)
- Bearing – inspect for wear and lubricate
- Inspect indoor coil if accessible
- Confirm proper return air and size
- Inspect Condenser Coil
- Refrigerate – monitor operating pressures
- Safety Devices – inspect for proper operation
- Electrical Disconnect Box – inspect for proper rating and safe installation
- Electrical Wiring – inspect and tighten connections
- Test/inspect contractors for burned, pitted contacts
- Inspect electrical for exposed wiring
- Inspect and test capacitors
- Inspect fan blade
- Clean condenser coil and remove debris
- Inspect service valves for proper operation
- Measure Supply/Return temperature differential
- Inspect ductwork for energy loss
- Compressor – monitor, measure amperage and volt draw and wiring connections
- Check Unit for Time Delay Relay
- Check Unit for Isolation Pads
- Inspect suction line for proper fittings
- Inspect all fittings for signs of oil and/or leakage
- Check lines and fittings with refrigerant leak detector
- Check the condition of Blower Belt, if applicable
17 point Energy Saving and Safety Heater Tune up
- Test system for carbon monoxide
- Test for gas leaks
- Test ignition system for safe and proper operation
- Test safety and control circuits
- Inspect duct system and airflow
- Inspect for combustible material around furnace
- Wash or replace standard 1-inch filter
- Visually inspect heat exchanger for separations
- Tighten and inspect all electrical wiringTest exhaust system for proper venting
- Measure amperage and voltage of motors
- Measure and adjust gas pressure for peak efficiency
- Clean and lubricate blower assembly
- Brush, clean, and vacuum burner compartments
- Measure Supply/Return temperature differential
- Calibrate and level thermostat
- Clean furnace exterior
- Inspect Secondary Motor Control